Quick question - I hope:
If I add additional network adapters to each of the cluster nodes, or enable adapters that were disabled when the cluster was built, do I have to do anything special to make them part of the cluster? Obvisouly each node needs to have the same IP settings, but will the cluster just see them and start using them or do I need to run something?
And if I want to make them another virtual network for Hyper-V, should I do that first before updating the cluster config or is there some order that needs to be followed? I'll be doing some reading too, just trying to plan ahead and want to do it the correct way without causing problems.
Thanks!